List of Figures

| Table of Contents | List of Figures | List of Tables |

Figure 1-1. Comparison of Vault and System "Stubby" Rack Boxes

Figure 1-2. Exclusive OR Reconstruction Process Example

Figure 1-3. Disk-Down LED Behind the Disk Drive Front Panel

Figure 1-4. Disk-Down LED Location Viewed from Front

Figure 1-5. RAID Controller Status LEDs

Figure 2-1. Configuring a Drive Sled for the RAID Box

Figure 2-2. RAID Backplane Configuration with Single-ended Non-RAID Drives Installed

Figure 2-3. RAID Backplane Configuration with Differential Non-RAID Drives Installed

Figure 2-4. RAID System Rack "Stubby" SCSI Box Backplane

Figure 2-5. RAID Vault Box Backplane

Figure 2-6. SCSI Drive ID Selection and Jumper Plug Selection

Figure 2-7. RAID Controller ID Selector and Board Jumpers

Figure 2-8. SCSI ID and LED Function Cable

Figure 2-9. Vault RAID SCSI Box Cabling and Termination

Figure 2-10. "Stubby" RAID Box Cabling and Termination

Figure 3-1. Installing the Optional RAID SCSI Drive Box

Figure 3-2. RAID SCSI Box Cable Routing in the System Rack

Figure 3-3. Installing the RAID SCSI Box in the Vault Chassis

Figure 3-4. System to Vault Box SCSI Connection Example

Figure 3-5. Installing or Removing a RAID Drive

Figure 3-6. Removing the Controller

Figure 3-7. Replacing the RAID Controller

Figure 3-8. Removing the Drive Tray and Installing the Full-height Drive

Figure A-1. Removing a RAID Box from the Vault

Figure A-2. Remove the Screws from the Disk and Sled Assembly

Figure A-3. Configuring the Converted Disk

Figure A-4. The 2.0 GB Drive Settings

Figure A-5. Installing Disks in the RAID Box