Table A-1 and Table A-2 describe the physical characteristics and the environmental specifications for the Everest rackmount systems. Table A-3 and Table A-4 list the specifications for both of the supported monitors. Refer to the CHALLENGE/Onyx Site Preparation Guide for additional information, including the power requirements.
 | Note: Refer to the owner's guide specific to the system (Challenge or Onyx) for additional system specifications. For example, see the CHALLENGE™ Rackmount Owner's Guide, p/n 007-1735-xxx for servers and or the Onyx™ XL Rackmount Owner's Guide, p/n 007-1736-xxx for graphics systems. |
The physical dimensions of the rackmount chassis are shown in Table A-1
Table A-1. Physical Characteristics
Dimension | Size |
|---|---|
Height | 52.3 in. (133 cm) |
Width | 27.0 in. (68.6 cm) |
Depth | 48.0 in. (122 cm) |
Weight | 540-800 lb (245-363 kg), Challenge |
Shipping Weight | Up to 1200 lb (545 kg) |
The environmental requirements are shown in Table A-2.
Table A-2. Environmental Requirements
Temperature | Range |
|---|---|
Operating Temperature | 15° to 35° C |
Nonoperating Temperature | –40° to 60° C |
Thermal Output | 9600 BtU/hr, maximum |
Heat Dissipation | 10,900 BtU/hr, chassis |
Relative Humidity | 20% to 80%, noncondensing |
The specifications for the 21-inch Hitachi and the 19-inch Mitsubishi color monitors are provided in Table A-3 and Table A-4, respectively.
Table A-3. 21-inch Hitachi Monitor
Parameter | Characteristics |
|---|---|
CRT Type | 21 (20V) inches diagonal, 0.28 mm dot pitch, black matrix, bonded A/R antistatic panel, short persistence |
– Input Signal | 0.714 Vpp analog |
– Video | Separate H,V, or Composite H/V |
– Sync | TTL level or Sync on Green at 0.3 Vpp |
Resolution |
|
– Horizontal | Up to 1600 dots |
– Vertical | Up to 1200 lines |
Video Bandwidth | 110 MHz |
Horizontal Scan Freq | 78 kHz |
Vertical Scan Freq | Up to 120 Hz |
Active Display Area | Active display area is changed by the graphics board standard. |
– Horizontal | 370 mm |
– Vertical | 285 mm |
Misconvergence | Less than 0.3 mm at center, 0.5 mm maximum at corners. |
Power Supply | AC 100 to 120/200 to 240 V |
Dimensions | 488 (W) x 467 (H) x 534 (D) mm (includes tilt and swivel base) |
Weight | 36 kg (40 kg packed) |
Temperature |
|
– Operating | 5° to 40° C |
– Nonoperating | –20° to 60° C |
Relative Humidity |
|
– Operating | 5 to 95%, noncondensing |
– Nonoperating | 5 to 95%, noncondensing |
Table A-4. 19-inch Mitsubishi Monitor Specifications
Parameter | Characteristics |
|---|---|
CRT Type | 20 (19V) inches diagonal, 0.31 mm dot trio pitch, black matrix, bonded A/R antistatic panel, short persistence |
Input Signal |
|
– Video | 0.714 Vpp analog |
– Sync | Sync on Green 1.0 Vpp RGB analog |
Resolution |
|
– Horizontal | Up to 1280 dots |
– Vertical | Up to 1024 lines |
Horizontal Scan Freq | 30-78kHz |
Vertical Scan Freq | 50-130Hz |
Active Display Area | Active display area is changed by the graphics board standard. |
– Horizontal | 343 mm |
– Vertical | 274 mm |
Power Supply | AC 100 to 120/200 to 240V, 50/60Hz, 155W (max) |
Dimensions | 495 (W) x 493 (H) x 543 (D) mm (includes tilt and swivel base) |
Weight | 36 kg (40 kg packed) |
Temperature |
|
– Operating | 0 ° to 40° C
|
– Nonoperating | –20° to 60° C |
Relative Humidity |
|
– Operating | 10% to 95%, noncondensing |
– Nonoperating | 10% to 95%, noncondensing |