List of Figures

| Table of Contents | List of Figures | List of Tables |

Figure 1-1. Locating the XIO Tri-Module

Figure 1-2. Powering Off the Octane2 Workstation

Figure 1-3. Removing the Monitor Cable

Figure 1-4. Attaching the Wrist Strap

Figure 1-5. Identifying the Compression Connector

Figure 1-6. Removing the XIO Tri-Module Screws

Figure 1-7. Unlatching the XIO Tri-Module

Figure 1-8. Removing the XIO Tri-Module

Figure 1-9. Placing the XIO Tri-Module on Its Side

Figure 1-10. Placing a Cap on the XIO Compression Connector

Figure 1-11. Placing the Primary Head Graphics Boards Toward the Top of the Workstation

Figure 1-12. Inserting the Dual Head XIO Module

Figure 1-13. Latching the Dual Head XIO Module

Figure 1-14. Replacing the Dual Head XIO Module Screws

Figure 2-1. Identifying the Monitor Cables

Figure 2-2. Placing the Monitors Side by Side

Figure 2-3. Connecting the Monitor Signal Cables

Figure 2-4. Placing the Secondary Monitor Above the Primary Monitor

Figure 2-5. Connecting the Monitor Signal Cables

Figure 2-6. Connecting the Secondary Monitor Power Cable

Figure 2-7. Powering On the Octane2 Workstation

Figure 5-1. Identifying the Compression Connector

Figure 5-2. Removing the Dual Head XIO Module Screws

Figure 5-3. Unlatching the Dual Head XIO Module

Figure 5-4. Removing the Dual Head XIO Module

Figure 5-5. Placing a Cap on the XIO Compression Connector

Figure 5-6. Inserting the XIO Tri-Module

Figure 5-7. Latching the XIO Tri-Module

Figure 5-8. Replacing the XIO Tri-Module Screws

Figure B-1. Identifying the Bristled Pad of the Compression Connector

Figure B-2. Spraying the Compression Connector