List of Figures

| Table of Contents | List of Figures | List of Tables |

Figure 1-1. Locating the XIO Module

Figure 1-2. Powering Off the OCTANE Workstation

Figure 1-3. Removing the Monitor Cable

Figure 1-4. Attaching the Wrist Strap

Figure 1-5. Identifying the Compression Connector

Figure 1-6. Removing the XIO Module Screws

Figure 1-7. Releasing the XIO Module

Figure 1-8. Removing the XIO Module

Figure 1-9. Placing the XIO Module on Its Side

Figure 1-10. Placing a Cap on the XIO Compression Connector

Figure 1-11. Identifying the Baffle and Blank Panel 

Figure 1-12. Removing the Baffle

Figure 1-13. Removing the Blank Panel

Figure 1-14. Inserting the Secondary Graphics Board

Figure 1-15. Removing the Cap From the XIO Compression Connector

Figure 1-16. Placing the Primary Head Graphics Boards Toward the Interior of the Workstation

Figure 1-17. Replacing the XIO Module

Figure 1-18. Inserting the XIO Module

Figure 1-19. Replacing the XIO Module Screws

Figure 1-20. Locating the System Label

Figure 2-1. Identifying the Primary Head Graphics Board

Figure 2-2. Removing the Screws From the Secondary Graphics Board

Figure 2-3. Placing a Blank Panel on the XIO Module

Figure 2-4. Installing the Baffle Across Two Blank Panels

Figure 3-1. Identifying the Monitor Cables

Figure 3-2. Placing the Monitors Side by Side in a SI/SI Configuration

Figure 3-3. Connecting the Monitor/Workstation Cables in an SI/SI Configuration

Figure 3-4. Connecting the Monitor Cables in a SSI/SI or MXI/SI Configuration

Figure 3-5. Placing the Secondary Monitor Above the Primary Monitor

Figure 3-6. Connecting the Monitor/Workstation Cable in an SI/SI Configuration

Figure 3-7. Connecting the Monitor/Workstation Cable in an SSI/SI or MXI/SI Configuration

Figure 3-8. Connecting the Secondary Monitor's Power Cable

Figure 3-9. Powering On the OCTANE Workstation

Figure 5-1. SI Graphics Board in Slot A

Figure 5-2. Removing the Primary SI Graphics Board From the XIO Module

Figure 5-3. Placing the Secondary SI Graphics Board Into Slot A

Figure 5-4. Identifying the Primary SSI Graphics Board in Slots D and A

Figure 5-5. Removing an Primary SSI Graphics Board

Figure 5-6. Removing the Secondary SI Graphics Board

Figure 5-7. Placing the Secondary SI Graphics Board in Slot A

Figure B-1. Identifying the Bristled Pad of the Compression Connector

Figure B-2. Spraying the Compression Connector

Figure C-1. OCTANE/SI Graphics Board

Figure C-2. OCTANE/SI With Texture Memory Option Board

Figure C-3. OCTANE/SSI Graphics Board

Figure C-4. OCTANE/MXI Graphics Board

Figure C-5. Back of Workstation