Chapter 1. Kit Contents
Prev   Next

Chapter 1. Kit Contents

This chapter summarizes the contents of the Sirius Video kits (D4-SIRIUS-G, D4-SIRIUS-S, and D4-SD1). Figure 1-1 shows all the Sirius Video components.

Note: If parts are missing, or if incorrect parts are included in the kit, log a call with TAC.

Figure 1-1. Sirius Video Kit Contents

Figure 1-1 Sirius Video Kit Contents

Table 1-1 lists part numbers for Sirius Video components in marketing codes for

Caution: The VO2 board is physically fragile and has active components on both sides, including thousands of tiny surface-mount parts, many of them on the back side. Exercise extreme care in handling the VO2. Setting the board down on a bench or the top of the chassis is likely to damage parts on the back side. Board components are extremely sensitive to electrostatic discharge; wear a grounded wrist strap and use all appropriate antistatic handling procedures

A cable kit with 30-foot cables can be ordered separately; its marketing code is DK-SIR30.

Note: If you are installing the Sirius Video option in a POWER Series or Crimson chassis, the CP chip on the GE8, GE10, or GE10V board must be uprevved to CP2 revision B. If it is not, the GE board must be swapped out.

If possible, ask the customer to run as root before your scheduled installation:

/usr/gfx/gfxinfo -v

For RealityEngine or RealityEngine2 graphics, the middle revision number for the GE board must be 1 (for example, 07X/011). If it is not, bring the appropriate board: GE8: 030-0546-001; GE10: 030-0325-004 or (required for CC3) 030-0325-005; GE10V: 030-0363-004 or (required for CC3) 030-0363-005.

Figure 1-2 shows components of the optional D1 serializer board (marketing code D4-SD1) for the Sirius Video breakout box.

Figure 1-2. Optional Serializer Board Kit Contents

Figure 1-2 Optional Serializer Board Kit Contents

Table 1-2 lists part numbers for the optional serializer board.

Table 1-2. Part Numbers for Sirius Video Breakout Box Components

Component

Part Number

Quantity

PC board assembly SD1

030-0510-004

1

Harness assembly, SD1 power

015-0203-001

1

Cable assembly

018-0427-002

3

Screws 6-32 x 1/4

7270805

2

BNC locknuts

7290800

8

BNC lock washers

7280801

8

Standoffs, 3/16 hex

7430104

6

Screws, 2-56 x 3/16

7270128

6

Screws, 4-40 x 3/16

7270143

6

Prev Table of Contents Next
Introduction  Chapter 2. Installing the Option