List of Figures

| Table of Contents | List of Figures | List of Tables |

Figure 1-1. Location and Sizes of CPU Module Standoffs on the IP26 Base Board

Figure 1-2. R8000 CPU Board Component Layout

Figure 1-3. POWER Indigo2 and POWER CHALLENGE M Block Diagram

Figure 2-1. SIMM Banks on the IP26 Affected by a Height Limitation

Figure 2-2. Opening and Removing the Top Cover

Figure 2-3. Removing the 5-1/4 Inch Drive Tray

Figure 2-4. Removing a SIMM

Figure 2-5. Removing Graphics and EISA Boards

Figure 2-6. Removing the Power Supply Screws

Figure 2-7. Disconnecting the Power Supply Cables

Figure 2-8. Unlatching and Removing the Power Supply

Figure 2-9. Removing the Backplane

Figure 2-10. Disconnecting Cables From the IP22 System Base Board

Figure 2-11. Removing the IP22 System Base Board

Figure 2-12. Installing the IP26 System Base Board

Figure 2-13. Reconnecting Cables to the IP26 System Base Board

Figure 2-14. Installing the Power Supply

Figure 2-15. Positioning the R8000 CPU Module

Figure 2-16. Seating the R8000 CPU Module Flex Cable

Figure 2-17. Preparing to Lower the R8000 CPU Module Into Place

Figure 2-18. R8000 CPU Module Lowered Into Place

Figure 2-19. Installing the R8000 CPU Module Screws and Insulating Sheet

Figure 2-20. Installing the Backplane

Figure 2-21. Installing Graphics Boards

Figure 2-22. Reinstalling the 5-1/4 Inch Drive Tray

Figure 2-23. Replacing the Top Cover