VMEbus™ FDDIXPress™ Board Installation Instructions

Document Number: 108-7030-040

CONTRIBUTORS

Written by Pablo Rozal, Carl Strasen, and Carlin Otto

Illustrated by Dan Young and Carlin Otto

Edited by Christina Cary

Production by Julia Lin

Engineering contributions by Mary Artibee, Rick McLeod, Jennifer Schlee, Don Coolidge, Vernon Schryver, Bill Calvert, Bill Nowicki, and Tim Wong

Silicon Graphics and IRIS are registered trademarks and IRIX, POWER Center, POWER Series, POWER Station, Crimson, CHALLENGE, CHALLENGE L, CHALLENGE XL, Onyx, and FDDIXPress are trademarks of Silicon Graphics, Inc. VMEbus is a trademark of Motorola Corporation. ST is a registered trademark of AT&T. AMD is a registered trademark and SUPERNET is a trademark of Advanced Micro Devices, Inc. BUSpacket is a service mark of Interphase Corporation.

© Copyright 1991-1995, Silicon Graphics, Inc.— All Rights Reserved

This document contains proprietary and confidential information of Silicon Graphics, Inc. The contents of this document may not be disclosed to third parties, copied, or duplicated in any form, in whole or in part, without the prior written permission of Silicon Graphics, Inc.

Restricted Rights Legend

Use, duplication, or disclosure of the technical data contained in this document by the Government is subject to restrictions as set forth in subdivision (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS 52.227-7013 and/or in similar or successor clauses in the FAR, or in the DOD or NASA FAR Supplement. Unpublished rights reserved under the Copyright Laws of the United States. Contractor/manufacturer is Silicon Graphics, Inc., 2011 N. Shoreline Blvd., Mountain View, CA 94039-7311.

FCC Warning

This equipment has been tested and found compliant with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Attention

This product requires the use of external shielded cables in order to maintain compliance pursuant to Part 15 of the FCC Rules.

VMEbus FDDIXPress Board Installation Instructions
Document Number 108-7030-040

Silicon Graphics, Inc.
Mountain View, California