Assign the hostname
Assign the network addresses
Perform the Bastille server lockdown
This chapter covers the following:
The procedures in this chapter assume that you are the superuser.
See the hardware documentation for additional information.
 | Note: The ISE software cannot be installed as a whole on a non-SGI system. Please consult the copyright notice enclosed with your ISE CD-ROM if you are considering using this software for any purpose other than the SGI server. |
To perform the installation, you will need the following CD-ROMs:
SGI ProPack 1.4 CD-ROM
SGI Internet Server Environment CD-ROM
The SGI factory basic I/O system (BIOS) settings on your SGI server boots your system off the floppy drive. To change the boot device, press Ctrl-Alt-Esc to enter SETUP mode during the boot process.
| Note: This may not work from a serial terminal emulator. |
To install the SGI ProPack overlay, do the following:
Insert the SGI ProPack 1.4 CD-ROM.
Mount the CD-ROM by entering the following:
# /bin/mount /dev/cdrom /mnt/cdrom
Change to the cdrom directory:
# cd /mnt/cdrom
Execute the INSTALL script:
# ./INSTALL
Unmount the CD-ROM:
# /bin/umount /mnt/cdrom
To install the ISE software, do the following:
Insert the SGI Internet Server Environment CD-ROM.
Mount the CD-ROM by entering the following:
# /bin/mount /dev/cdrom /mnt/cdrom
Change to the cdrom directory:
# cd /mnt/cdrom
Execute the INSTALL script:
# ./INSTALL
Unmount the CD-ROM:
# /bin/umount /mnt/cdrom
To activate configuration and Bastille Linux questions upon reboot, enter the following:
# /bin/touch /root/.SGICONF |
Return to the steps documented in “What Do I Need to Do?” in Chapter 1.