This appendix lists some of the common hardware used in both rack and deskside CHALLENGE and Onyx systems.
Table A-1. Selected Rack and Deskside Hardware
Part # | Description | Where Used |
|---|---|---|
Cable tie, max. 3/4" dia., .1" wide | Numerous locations | |
3/32 x .375 rivet | Numerous locations | |
1/8 x .163 rivet | Numerous locations | |
4-40 x 3/8" phillips pan-head screw | Numerous locations | |
4-40 x 3/16" phillips pan-head | SCSI adapter boards to IO4 board | |
4-40 x 1" knurled-head captive screw | DI1 and DI4 boards | |
2-56 x 1/4" phillips flat-head zinc-coated steel screw | Wedgelocks to mid- & backplanes | |
6-32 x 1/4" truss-head screw | VCAM to IO4 | |
10-32 x 3/8 phillips pan-head screw | Status panel | |
M4 x 5mm phillips pan-head screw | Deskside blower module FDDI cable to mounting plate | |
6-32 x 1/4" tap-tite phillips pan-head screw | Numerous locations | |
6-32 x 3/8" phillips pan-head screw | Backplane to chassis SCSI backplane to drive bulkhead Exhaust divider to backplane | |
6-32 nut | Ground wires on AC panel | |
#6 internal-tooth star lockwasher | Ground wires on AC panel | |
1/4"-20 locking hexnut | 48V wires on backplane | |
.265 x .562 flat washer | 48V wires on backplane | |
#4 split washer | DI1 and DI4 board captive screws |