List of Figures

| Table of Contents | List of Figures | List of Tables |

Figure 1-1. Turning Off the Workstation

Figure 1-2. Removing the Power Cable

Figure 1-3. Releasing the System Module

Figure 1-4. Removing the System Module From the Chassis

Figure 1-5. Laying the System Module Flat

Figure 1-6. Releasing the PCI Tray

Figure 1-7. Removing the PCI Tray from the System Module Viewed from the Side

Figure 1-8. Removing the Filler Panel: O2 R5000 Class Workstation

Figure 1-9. Removing the Screws from the Face Plate: R10000 Class Workstation

Figure 1-10. Removing the Face Plate: O2 R10000 Class Workstation

Figure 1-11. Removing the Filler Panel: O2 R10000 Class Workstation

Figure 1-12. Removing the PCI Tray

Figure 1-13. Attaching the Wrist Strap

Figure 1-14. Positioning the Flat Panel Monitor Adapter Board

Figure 1-15. Aligning the Flat Panel Monitor Adapter Board

Figure 1-16. Seating the Flat Panel Monitor Adapter Board, Viewed from the Side

Figure 1-17. Securing the Flat Panel Monitor Adapter Board: O2 R5000 Class Workstations

Figure 1-18. Returning the Lever to the Starting Position

Figure 1-19. Replacing the PCI Tray in the System Module Viewed from the Side

Figure 1-20. PCI Tray Seated Correctly

Figure 1-21. Replacing the PCI Tray in the System Module

Figure 1-22. Replacing the Face Plate

Figure 1-23. Replacing Screws on the Face Plate

Figure 1-24. Reinstalling the System Module in the Chassis

Figure 1-25. Securing the System Module in Place

Figure 1-26. Connecting the Power Cable

Figure 1-27. Attaching the Interface Cable to the Adapter Board

Figure 1-28. Removing the Flat Panel Monitor Adapter Board

Figure 2-1. Xsetmon Main Screen

Figure 2-2. 1600SW Flat Panel Settings Control Panel

Figure 2-3. Calibrate Flat Panel Window

Figure 2-4. Attaching the ColorLock Sensor to the Flat Panel Monitor

Figure 2-5. Connecting the ColorLock Sensor Cable to the Flat Panel Monitor

Figure 3-1. Confidence Tests Window