This chapter discusses the controls and connectors of the Vault and
Figure 2-1 shows the major components of the Vault.
This section describes the front and rear components of the SCSIBox 2. Figure 2-2 and Figure 2-3 show the major components of the box.
These components are located on the front of the SCSIBox 2 (see
opens and closes using two quarter-turn, wing-nut fasteners near the top corners of the box. Be careful not to overturn the fasteners or else they may break off.
|Caution: The door must be in place during operation to comply with FCC regulations and for proper air flow.|
controls power to all the drives.
house the SCSI drives and drive sleds. The shelves are removable to accommodate full-height drives.
|Note: Each full-height drive occupies two half-height slots.|
These major components are located on the back of the SCSIBox 2 (see Figure 2-3):
|SCSI In (A/B)|
provides a 68-pin SCSI-2 differential connector.
|Note: Each SCSI box provides two SCSI In connectors for disk striping and increased I/O throughput.|