List of Figures

| Table of Contents | List of Figures | List of Tables |

Figure 1. Hardware Inventory List

Figure 2. Displaying the Installed Version of IRIX

Figure 3. Powering Off the Workstation

Figure 4. Removing the Monitor Cable

Figure 5. Attaching the Wrist Strap

Figure 6. Identifying the Compression Connector

Figure 7. Loosening the XIO Module Screws

Figure 8. Releasing the XIO Quad-Module

Figure 9. Removing the XIO Quad-Module

Figure 10. Loosening the XIO Tri-Module Screws

Figure 11. Releasing the XIO Tri-Module

Figure 12. Removing the XIO Tri-Module

Figure 13. XIO Tri-Module

Figure 14. Inserting the XIO Tri-Module

Figure 15. Tightening the XIO Tri-Module Captive Screws

Figure 16. Reconnecting the Monitor Cable

Figure 17. XIO Tri-Module with VPro Graphics I/O Ports

Figure 18. Powering On the Workstation

Figure 19. Identifying the Slots Used by an XIO Option Board

Figure 20. Placing the Cap on the XIO Compression Connector

Figure 21. Removing the Screws from the Blank Panel

Figure 22. Removing the Blank Panel

Figure 23. Installing the Screws

Figure 24. Removing the Cap from the Option Board Compression Connector